Menu

Reply To: SNES Sync failure after v0.78aud fw upgrade

Home Forums OSSC OSSC – Discussion and support SNES Sync failure after v0.78aud fw upgrade Reply To: SNES Sync failure after v0.78aud fw upgrade

#14687

brpajo
Participant

Ok, so I went ahead and tried 0.78aud again. LCD sync information does not change between 0.77aud and 0.78aud. But I did discover one thing, if I reset settings on the OSSC upon turning it on with the snes on, the problem goes away. I tried this twice, I powered down the snes and the OSSC (0.78aud fw), then turned them both back on and the problem was there again. I then reset settings on the OSSC and the problem went away again. I’m using default settings all the way through, I’ve yet to really play with the settings, as I’ve only had it a week, so I really wouldn’t tinker with calibrations or settings quite yet, so I’m always on default settings. I have played with line 2 through 4x mode, but that’s it. By the way, this problem persists on line 2 through 4x mode on my Sony 4K tv.