Menu

Reply To: OSSC v1.6 build debugging

Home Forums OSSC OSSC – DIY Kit support OSSC v1.6 build debugging Reply To: OSSC v1.6 build debugging

#16295

krivx
Participant

Yes, the centre pads are soldered. I tinned the pads lightly and added flux, then placed the chips, then hot air, then soldered the pins.

I just tried putting together a Quartus install to see if it can communicate with the FPGA and the Win10 USB Blaster drivers cause repeat BSOD when using some clone USB Blasters 🙁 I’ve ordered another cheap clone.

I have a spare FPGA (same Asian vendor) and I’m OK at replacing QFPs so that may be the last resort…