Menu

OSSC Display Garbled or Empty

Home Forums OSSC OSSC – Discussion and support OSSC Display Garbled or Empty

This topic contains 2 replies, has 3 voices, and was last updated by  vasilas432 1 month ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #16078

    MarkBogaard
    Participant

    When I turn on the OSSC after it has had no power for a few hours everything seems fine, the display shows firmware version and dates + creator. But when I connect a console (doesn’t matter what console) the display briefly shows the resolution and other data, but then after a while it either shows garbled text or far more often nothing at all. The video and audio output do keep working during all this.

    Using the remote does not reactivate the text, neither does turning it off. I have to turn off the power for a while (more than a few minutes) for it to show the normal text again when I turn it on.

    Is anybody else seeing this? Any advice on what to do?

    Using the new 1.6 version received in september.

    • This topic was modified 1 month, 1 week ago by  MarkBogaard.
    #16080

    BuckoA51
    Keymaster

    That’s not normal at all, I’m afraid that might call for an RMA. E-mail in using the contact form, https://www.videogameperfection.com/contact-us/ and I’ll sort it.

    #16226

    vasilas432
    Participant

    Yesterday I had the same experience. OSSC was blinking mad and no signal. I had to turn it off to fix it.
    If it does it again I will report here. Mine is 1.6 version too.

    • This reply was modified 1 month ago by  vasilas432.
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.